Cole Parmer Masterflex 7583-50, Руководство по эксплуатации

Страница: 6 / 12

SETUP AND DRIVE OPERATION
Wiring
The Model 7583-50 drive is intended for hazardous (classified) loca-
tions requiring equipment with a Class 1 Group D rating where gases
or vapors that have an ignition temperature greater than 280°C are
present. Installation of the 7583-50 drive system must be made in ac-
cordance with the National Electrical Code ANSI/NFPA 70 and any
applicable local codes.
The motor must be wired such that the output shaft of the MOTOR
rotates in a clockwise direction when facing the motor shaft. See the
wiring diagram below.
2
WIRING DIAGRAM
For Model 7583-52, the motor which is supplied by the customer must
be wired so that the output shaft of the motor rotates in a clockwise
direction when facing the motor shaft.
CAUTION: Failure to wire the system in the manner prescribed
can result in premature failure of the mechanical
speed reduction system and will result in voiding
the warranty.
Untitled-1 2/17/04, 7:27 AM 6