Cole Parmer FSB-200 Series, Инструкция по эксплуатации

Страница: 8 / 36

7
ENVIRONMENTAL CONDITIONS
This equipment is designed to operate under the following conditions:
• Indoor use
• Use in a well-ventilated area
• Ambient temperature range +5°C to +40°C
• Altitude to 2000 m (6500 ft.)
• Relative humidity 80%
• Mains supply fluctuations not exceeding 10%
• Overvoltage category II IEC60364-4-443
• Pollution degree 2 IEC664
GUARANTEE
Notwithstanding the description and specification(s) of the units contained in the operator’s manual, Antylia
Scientific hereby reserves the right to make such changes as it sees fit to the units or to any component of the
units.
This manual has been prepared solely for the convenience of Antylia Scientific customers and nothing in this
instruction book shall be taken as a warranty, condition or representation concerning the description,
merchantability, fitness for purpose or otherwise of the units or components.
OPERATOR MAINTENANCE
NOTE: THAT THIS EQUIPMENT SHOULD ONLY BE DISMANTLED BY PROPERLY TRAINED PERSONNEL.
REMOVING THE SIDE, FRONT OR REAR PANELS EXPOSES POTENTIALLY LETHAL MAINS VOLTAGES.
THERE ARE NO OPERATOR MAINTAINABLE PARTS WITHIN THE EQUIPMENT.
In the unlikely event that you experience any problems with your unit which cannot easily be remedied, you
should contact your supplier and return the unit if necessary. Please include any details of the fault observed and
remember to return the unit in its original packing. Antylia Scientific accept no responsibility for damage to units
which are not properly packed for shipping: if in doubt, contact your supplier.
1. Cleaning
Before cleaning your unit ALWAYS disconnect it from the power supply and allow it to cool below 50°C.
Your unit can be cleaned by wiping with a damp soapy cloth. Care should be exercised to prevent water from
running inside the unit. Do not use abrasive cleaners.
2. Over-temperature cut-out
In the event of no heater power, check the mains plug and lead. Repeated operation of the cut-out indicates a
serious fault: you may need to return the unit to your supplier for repair.
3. Fuses
Your unit is protected by one or two fuses. These should only be changed by suitably qualified personnel. If the
fuses blow persistently, a serious fault is indicated and you may need to return the unit to your supplier for
repair.