Cole Parmer 16 Series, Руководство по эксплуатации

Страница: 17 / 41

17
Control Misc
Setup
SELECT
MENU
Comm. Mfg.
RS-232 Data Menu
Figure 13. PC Series Select Menu Display
Control Setup Mode
The Control Setup Mode is accessed by pressing the center button above “Control Setup” on the select
menu display. This mode allows the user to set up most parameters commonly associated with PID
control. PC Series Pressure Controllers allow the user to select how the set-point is to be conveyed to
the controller, what that set-point is if control is local, and what the Proportional and Differential terms
of the PID control loop will be. The UP and DOWN buttons for adjusting variables can be held down
for higher speed adjustment or pressed repeatedly for fine adjustment. If your controller is difficult to
reach or you prefer “dial up” set-point adjustment, please consider our Local Set-point Module (LSPM)
described on page 39.
Select Loop Input
>P 400 >Press >Analog
D 5000 Serial
AUT0off
Local
Set 0.00
Control
Up Down Setup
Figure 14. PC Series Control Setup Display
Input
– PC Series Pressure Controllers normally ship defaulted to analog control as indicated in Figure
14 above. To change how the set-point will be conveyed to the controller push the button in the upper
right hand corner just above the dynamic label “Input” until the arrow is directly in front of the desired
option. The controller will ignore any set-point except that of the selected input and it will remember
which input is selected even if the power is disconnected.