22
A) Pump Fed Machines
With your clean, sanitized hands, install the feeding
elbows into the cylinder feed holes. Next slide the
elbow connecting tube into the pump cover hole.
Holding the connecting tube inside the pump cover
hole, slide the feeding elbow away from the pump.
This will seat the tube and elbow to prevent the
tube from sliding out when under pressure.
Fill each mix tank with fresh liquid mix. Each mix
tank has a maximum capacity of 18 quarts. The
minimum recommended mix quantity is 6 quarts.
With the mix tanks filled with liquid mix and the
elbows connected to the pumps, you can now prime
the cylinders. To prime the cylinders, press the
“Select” button on the touch pad, selecting the
“Beater” only mode. Allow the machine to run for
approximately one minute the press the “Stop”
button.
Carefully push the plastic bleed plunger, which
extends from the front of the feeding elbow. This
will allow the air to escape from the cylinder.
When all of the pressure is released, press the
“Select” button and switch to the “Beater” only
mode for one minute. After one minute, press the
“Stop” button and carefully push the plastic bleed
plunger, which extends from the front of the
feeding elbow.
Repeat this process until a steady stream of mix
only is flowing from the bleed hole on the feeding
elbow.
You may now start the freezing process by pressing
the “Select” button (#571.2) and selecting the
Automatic mode.
The initial freeze time is approximately 4-7
minutes. Do not dispense product until the machine
has cycled off. The draw rate, portion size, and mix
viscosity will determine the final regulator tube
setting. Adjust for your specific application.
570
571.1
571.2
