13
Part IV - Assembling the Freezer
A)
Assembling the Beater / Augers
After completing the Cleaning Operation, you are
now ready re-assemble the freezer. First locate the
parts needed to assemble both beater / auger
assemblies. A) End pusher, B) Beater frame,
C) Idler, D) Beater seal, E) Scraper Blades (3per),
F) Blade bumpers (2 per blade)
Install the rubber bumpers into each scraper blade.
NOTE: Keep the large end of the bumper opposite
the blade groove.
Assemble the scraper blades onto the beater frame
by inserting the blade into the support and rotating
downward. Install the end pusher into the beater
frame making sure to engage the alignment notch of
both the beater and end pusher.
Install the idler into the beater frame by placing it
through the end pusher.
NOTE: When installed correctly, the idler should
rotate freely inside the beater frame. If the idler
does not rotate freely, it is incorrectly installed
and MUST NOT be installed into the machine.
Repeat the above instructions until the idler is
installed correctly
.
Next, lubricate the rear of the metal washer on the
beater frame with three 3/8 ” drops of the sanitary
lubricant spaced equally on the washer.
Slide the rubber beater seal onto the beater frame
end. Using the sanitary lubricant, place three more
3/8” drops of lubricant on the flat side of the beater
seal (next to the beater shaft). DO NOT lubricate
the “V” groove of the seal as this is not the sealing
surface of the seal.
D
