9
EN
GL
IS
H
6. Power switch
The power switch (3) has three settings:
•
I
On
•
0
Off
•
Auto
Power tool socket – The wet and dry vacuum cleaner starts and stops
automatically when the machine connected to the machine socket is turned on
and off.
7. Power tool socket
The product has a power tool socket (9) which is designed to start the wet and dry
vacuum cleaner automatically.
• Connect the plug from a circular saw or similar machine to the power tool socket.
Then connect the suction hose (B) between the wet and dry vacuum cleaner and
the dust extractor port of the circular saw (or whatever machine is connected).
Set the power switch to the
Auto
position.
• The ON and OFF control of the wet and dry vacuum cleaner will now be controlled
by the connected power tool. The wet and dry vacuum cleaner will switch on as
soon as the connected power tool has started and switch off about five seconds
after the connected power tool has been switched off.
Note:
The power tool socket must not be loaded over 2380 W.
8. Repair and maintenance
1.
Warning!
Always make sure the plug is disconnected before servicing or adjusting.
2. Remove the suction hose.
3. Open the over-centre catch and remove the motor/top from the container.
4. Clean the container and hose and make sure that they are dry before putting
the product away for storage.
Replace or clean the filters whenever needed. Make sure that the hose, filter, couplings and
mains lead are undamaged. If the mains lead is damaged, have it replaced by a professional.