COINWASH T3300S, Руководство по обслуживанию

Страница: 22 / 99

12. Error codes
12
Service
manual
487 0329 21
12.2
General note regarding error codes related to overheating (E01, E02, E08) 12.4
E 01 Inlet air (electric heated dryer only) - input temperature is too high 12.5
The temperature of the air entering the drum is too high
(measured by thermistor element).
Inlet air (gas heated dryer only) - input temperature is too high 12.6
The temperature of the air entering the drum is too high
(measured by thermistor element).
E 02 Outlet air - Output temperature is too high 12.7
The temperature of the air leaving the drum is too high (measured by thermistor
element).
E 03 Inlet air - Sensor has short-circuited 12.8
The thermistor element measuring the air inlet temperature to the drum,
or the wiring to the sensor has shorted.
E 04 Outlet air - Sensor has short-circuited 12.9
The thermistor element measuring the air outlet temperature from the drum,
or the wiring to the sensor has shorted.
E 05 Blower motor –The thermal protection switch in the motor, 12.10
or its harness, is open.
E 06 Drum motor – The thermal protection switch in the motor, 12.11
or its harness, is open.
E 07 Not in use on this model.
E 08 Inlet and Outlet air protection thermostats 12.12-12.14
One of the proctection thermostats has opened due to overheating.
E 08 check list 12.26
Decription Page Error
code
Error codes - Overview E 01 - E 18 and E 99
The dryer is equipped with an automatic diagnostic system.
Operating problems are displayed as blinking error codes. Whenever an error occurs, the
dryer stops operating.
Except where noted, error codes are cleared by disconnecting the power or by entering
the service program.
Error analysis
An diagnostic procedure is provided for each error code. If an error has not been
corrected after the procedure, please contact the manufacturer for additional assistance.