Coinco 9300-S Series, Руководство по эксплуатации и обслуживанию

Страница: 5 / 28

Page 5
INSTALLING THE CHANGER
See Figure 2
1. Remove the acceptor from the changer by
releasing acceptor latches and pulling the top of
the acceptor forward, away from changer.
Unplug ribbon cable from changer. Free lower
acceptor studs from changer housing. With the
acceptor removed, set key holes in back of
changer housing over mounting screw in the
vendor. Tighten snugly.
2. Set desired vend price and changer options (see
Vend Price and Option Switch Settings).
3. Replace the acceptor by inserting bottom
acceptor studs into changer housing guides. Plug
the acceptor ribbon cable into the changer.
Press top of acceptor into changer housing until
top acceptor studs lock into changer's acceptor
latches.
4. Connect changer to desired options. Plug
changer into an 8-pin vendor socket.
5. Load coin tubes making sure all coins lie flat.
6. Test changer with a variety of coins to ensure
proper operation and vend price setting.
NOTE : SAVE THE COIN CHANGER CARTON.
Always store coin changer in its shipping carton
when not in use. This will keep the unit clean
and protected.
Section 2: Installation
SWITCH # PRICE/OPTION
1 ............................................. $.05
2 ............................................. $.10
3 ............................................. $.20
4 ............................................. $.40
5 ............................................. $.80
6 ........................................... $1.60
7 ........................................... $3.20
8 ........................................... $6.40
9 ........................................... NOT USED
10 .......................................... $ coin acceptance
11 .......................................... LO $.25
12 .......................................... escrow until select
VEND PRICE AND OPTION
SWITCH SETTINGS
See Figure 2
1. Unplug the coin changer
2. Remove the acceptor.
SWITCH # OPTIONS
9 NOT USED
10-$ACPT ON: Dollar coins will be accepted
OFF: Dollar coins will be rejected
11-LO $.25 ON: Quarters are directed to cashbox
once change tube has approximately
22 quarters
OFF: Quarters are directed to cashbox
once change tube is full
12-ESC-SEL ON: Changer allows complete escrow
until selection and delivery have
been made.
OFF: Changer allows escrow until vend
price is accumulated.
3. Located in the upper portion of the changer is a
single switch module with 12 rocker switches.
When the top of the rocker switch is pushed in, it
is in the ON position. The switches correspond
according to the following table.
4. The vend price is set by adding the value of
switches 1-8, which are in the ON position.
Example: switches 1,3 and 4 in the
ON position = $.65 vend price.
5. Set switches 1-8 to desired vend price. Make
sure vend price set on changer corresponds to
vend price indicated on front of vendor.
6. Set option switches 9-12 to desired setting.