English
10
4.3 Adjusting unit tilt
Stage Lite Led sc tilt, when floor mounted can be adjusted in a range of 120° as preferred. In order to adjust the tilt untight the “E”
handles sited on the sides of the supports, adjust the tilt angle as preferred then tight again the handles. Move the knobs in order to
orient the beams at the desired angle. The graduated board is a useful point of reference to achieve a sharp adjustment.
4.4 Replacing lenses
It is possible to mount optional lenses in order to get a different beam angle. The instruction for replacing the lenses are showed in
the following pictures. This operation must be done by qualified personnel.
-remove the frame or the IP65 panel from the bottom of the fixture by unscrewing the 4 screws, then remove also the other 2
screws placed underneath in order to unlock the inner block.
-remove the three adjusting knobs and the right side header from the fixture by removing the 7 screws; gently extract the inner
block from the body. Be careful not to tear cables that can be caught in the body.
- Replace the lenses needed taking care not to make pressure on the lens for any reason. If the operation is difficult to perform,
check for the correct orientation of the lens towards Its receptacle.
E
F
G
