English
12
WARNING!!
•The use of a thermal/magnetic circuit breaker is recommended. Strict adherence to regulatory norms is strongly
recommended.
•Stage Lite Led sc should not be powered through a dimmer as this may damage the internal switching power supply.
•Prior to connecting the device to mains power, ensure that the mains characteristics are within the recommended range
for use with the Stage Lite Led sc.
•all cabling and connections should be carried out by suitably qualified personnel.
6. Control signal connections
Stage Lite Led sc can operate in two modes:
1- using DMX512 control signal
2- automatic “STAND ALONE” or “MASTER/SLAVE” mode.
6.1 Control signal connection by XLR3 plugs.
The digital control signal is transmitted to the projector via a two pole cable screened as per International standards for the
transmission of DMX 512 data. The connection must be serial, using connectors XL3 male and female located on the back of
Stage Lite Led sc
labelled DMX512 IN e OUT (see diagram).
Pin 1= GROUND
Pin 2= DATA
-
Pin 3= DATA
+
ATTENZIONE !
Make sure that screening and conductors are not in contact one another or with the metal housing of the connector.
Pin#1 and housing never must be connected to the power supply unit.
