All the components of the
miniCYC MB
are available as replacement spares from your authorisded
Coemar
service centre. Accurate
description of the fixture, model number, and type will assist us in providing for your requirements in an efficient and effective manner.
In the table below are listed all the accessory of the
miniCYC MB
and the related
Coemar
code.
miniCYC MB is protected by various international patents which prohibit copying of the unit in total or in part.
OPER
:
PAN ENCODER Error
This message indicates that there is a problem with the PAN encoders. Check the sensors on the encoder wheel
located near the pan movement motor, as well as the relevant cabling.
OTER
:
TILT ENCODER Error
This message indicates that there is a problem with the TILT encoder locate on the fixture yoke. Check the sensors
on the encoder wheel located near the pan movement motor, as well as the relevant cabling.
SNER
:
SYNCHRONISM Error
The projector took a net frequency out of the admitted range and this does not enables the lamp controlled by
the mechanical relay to switch on to avoid problems to the control pcb.
DTER
:
DATA Error
The initial parameter settings are incorrect or corrupt; the projector has reloaded its factory default settings. Turn
the projector off and on again. Should the error reoccur, refer the unit to your authorised
Coemar
service centre
to have the EEPROM check and possibly replaced.
ADER
:
DMX ADDRESS Error
The projector is not receiving all DMX channels needed to operate correctly. Check the DMX address indicated on
the display and the channel numbers being outputted from the controller. Note that not all controllers will output
all 512 channels.
ER20
÷
ER99
:
SYSTEM Error
Turn the unit off and on again. If the error persists, contact your authorised
Coemar
service centre.
The projector is completely
immobile.
Projector not powered up.
The circuit breaker is switched off
The protection fuse is blown
Check that the mains power cable is connected
to power.
Set the circuit breaker to ON.
Disconnect the projector and replace the fuse.
The projector resets correctly, but
either does not respond, or
responds incorrectly, to DMX
signal.
Incorrect signal connection
Incorrect DMX address
Inspect the signal cable, rectify any incorrect
wiring, repair or replace any damaged cables or
connectors.
Check the DMX address.
The lamp turns off intermittently
The projector is too hot.
Let the fixture cool down.
Check that the air vents above the cooling fans
are not obstructed and that the fans are working
correctly.
Ensure that the ambient temperature is below
35 °C.
One of the fans does not work correctly and cau-
ses the overheating of the projector.
Question
Possible cause
Possible solution
17. Frequently asked questions
16. Error messages
15. Patents
Descrizione
Codice
1.
Maximum diffusion kit
9832
2.
4 leaf barndoor
9829
14. Accessory
13. Spare parts
25
English