Coemar Infinity Spot L, Инструкция по эксплуатации

Страница: 20 / 30

20
English
10.2 Aligning the lamp in the optical path
Aligning the lamp in the optical system is achieved via the 3 adjusters at the rear of the projector. This procedure
should be undertaken to maximize output, to avoid the possible overheating of the internal components due to the
incorrect focusing of the beam onto components not predisposed to high temperature. It is extremely important to
obtain a uniform distribution of light on all beams.
Alignment procedure
Alignment is carried out by using the 3 screws A, B and C showed in the picture below. The lamp should be on, black-
out and dimmer fully open, and no colours selected. If the lamp is not correctly aligned, a hot-spot to the most central
part of the beam possible and then flatten the beam to maximum uniformity. The combined regulation of the three
adjusters allows horizontal, vertical and axial regulation of the lamp.
Adjust lamp position by
turning screws A , B and C
High voltage inside.
Disconnect from power supply before opening
The lamp can be re-ignited only after 10 minutes.
Do not attempt
Case extremely hot.
Loosen
to relamp
Loosen
to relamp
WARNING! WARNING!
A
C B
lamp: Lock-IT ® HTI ® 1000W/PS base:PGJX28