8.8. Resetting the counter
The lamp life counter needs to be reset to zero at every lamp change to provide accurate information on lamp life.
When turning on the
iSpot S
, simultaneously hold down the
+
and
– buttons
. The projector will restart with its counter reset.
The projector has reset the
LIFE
counter.
To verify that this operation has occured:
1.
Press the
menu
button and then press
enter
.
2.
Press the
+
or
-
buttons until
MEAS
is displayed, then press
enter
.
3.
Press the
+
or
-
buttons until
HOUR
(hours) is displayed, then press
enter
.
4.
Press the
+
or
-
buttons until
LIFE
(lamp life) is displayed, then press
enter
.
5.
If the display shows
0000
, the counter has been reset.
N.B.
You may also wish to verify that other electronic counters such as
LIFS
(total lamp operating lives) and
UNIT
(total proejctor ope-
rating life) have remained unaltered.
The
iSpot S
utilises the Philips MSR GOLD 1200 SA/SE PGJ50 base lamps.
These lamps are available via your
Coemar
distributor or service centre.
The fixture’s internal temperature can reach 250° C after 5 minutes, with a maximum peak of 450° C; ensure that the lamp is cold prior
to attempting removal. The fixture should be allowed to stand and cool for 10 minutes prior to its removal.
The lamps are part of the mercury vapour family of discharge lamps and must be handled with great care. The lamp operates at high
pressure, and the slight risk of explosion of the lamp exists if operated over its recommended life. We recommend, therefore, that the
lamp be replaced within the manufacturer’s specified lamp life.
9.1. Lamp installation
1.
Use a suitable tool to loosen the four screws “
A
“ which affix the lampholder assembly at the rear of the projector.
LO
O
S
E
N
T O R
E
-L
A
M
P
Do not install on flammable surfaces.
Min distance from flammable materials to all exterior surfaces: 0.5m.
The lamps can be re-ignited only after 10 minutes. Do not attempt hot restrike.
Important safety information, see instruction manual before use.
LO
O
S
E
N
T O R
E
-L
A
M
P
LO
O
S
E
N
T O R
E
-L
A
M
P
LO
O
S
E
N
T O R
E
-L
A
M
P
ATTENTION!!
Disconnet the unit from mains power prior to attempting lamp installation or replacement
Make sure the projector is sufficiently cooled.
Lamp
Philips MSR 1200 SA/DE
Coemar code
105099/2
Power
1200W
Luminous flux
110.000 lm
Colour temperature
6000° K
Base
SFc10-4
Approximate lamp life
750 ore
9. Lamp installation and alignment
m
en
u
m
enu
en
ter
en
te
r
+
+
17
English
