https://codelocks.zohodesk.eu/portal/en/kb/articles/cl5500-installation-instructions
until finger tight. Fit the alignment insert over the spindle. Screw the fixing bolts through to the front plate. (See
diagram D).
13. Check that the alignment insert slides freely into the fixing plate without binding. If it is tight, loosen the
fixing bolts slightly and adjust the position of the fixing plate until the alignment insert is centred.
Tighten the fixing bolts and check alignment. Do not over-tighten the bolts as this may cause the door to distort
and affect the lock function.
PLEASE REMOVE THE ALIGNMENT INSERT.
14. Connect the cables, storing any excess cable within the door. Then install the batteries.
15. Fit the back plate over the fixing plate using the four socket head screws.
16. Fit the cylinder cover and outside handle to the front plate.
17. Fit the inside handle to the back plate.
18. The inside handle will now retract the latchbolt. The outside handle will turn freely without retracting the
latch. Enter the factory Master Code #12345678. The keypad will flash blue and the outside handle will now
retract the latch.
19. Fitting the strike plate
Position the strike plate on the door frame so that the aperture lines up with the flat of the latchbolt, and NOT the
plunger Mark the positions of the fixing screws and draw around the aperture of the strike plate Chisel out the
