Code Blue
•
259 Hedcor Street
•
Holland, MI 49423 USA
•
800.205.7186
•
www.codeblue.com
GU-142-F
page 30 of 61
IP5000 2.0 Series
Administrator Guide
Hardware Settings
The IP5000 speakerphone hardware settings are configured by:
1. Selecting
Hardware Settings
under
Code Blue
(see far left-hand column).
2.
Select the appropriate Button Count, Keypad Available and Public Address Available
settings under the Interface section. Public Address Available is utilized when the IP5000 is
controlling the optional Code Blue PAS components (i.e. CB 1, CB 2, CB 5 with Public
Address or WM180).
3. The
Power Sources
section allows you to select the power sources connected to the
IP5000.
Note: By default, A/C is selected. If the IP5000 power source is solely PoE, failure to un
check the A/C Box will result in SNMP traps noting the failure of A/C, when in fact there is
no A/C power applied.
4. Checking
Aux Output 1 or 2
will enable the auxiliary output relay. By default, the port is set
to enable (Toggle State) when used in an Action Script.
When
momentary toggle
has been selected, the called party now has the ability to
activate the auxiliary output remotely for the time period chosen via DTMF tones, from their
phone’s keypad.
Note: Momentary toggle is intended for remote control use by the called party. It’s important
to understand that scripted use of the aux output not be used on any aux output port that
has been selected to act in the momentary (remote control aspect) toggle function. Also, it is
not recommended to use General Settings > Incoming Calls > Aux Output 1 or 2’s Enable
on Incoming Call check box.
5. With selections made, click
Save Changes
.