23
3.5 Remote control inputs (Ethernet)
The Ethernet link network connector allows you to access the LINUS5-C from a host computer for remote control, firmware
update and download ing DSP presets. Please note that for setting up proper network connec tion you need to use the
CODA Audio LINUS Control
software.
3.6 Power outputs
Both SPEAKON® connectors are connected to the channel A and channel B amplifier outputs. The pin configuration of the
SPEAKON® connectors is as follows:
Left
SPEAKON®
Output
Pin 1 + Channel 1 amplifier output
Pin 1 -
Channel 1 ground
Pin 2 + Channel 2 amplifier output
Pin 2 -
Channel 2 ground
Right
SPEAKON®
Output
Pin 1 + Channel 3 amplifier output
Pin 1 -
Channel 3 ground
Pin 2 + Channel 4 amplifier output
Pin 2 -
Channel 4 ground
Centre
SPEAKON®
Output
Pin 1 + Channel 1 amplifier output
Pin 1 -
Channel 1 ground
Pin 2 + Channel 2 amplifier output
Pin 2 -
Channel 2 ground
Pin 3 + Channel 3 amplifier output
Pin 3 -
Channel 3 ground
Pin 4 + Channel 4 amplifier output
Pin 4 -
Channel 4 ground
WARNING!
SPEAKON® connector marked with the lightning flashes indicate high voltages that are potentially life threatening.
Wiring to these terminals requires installation by an instructed person or the use of ready-made leads or cords.
Custom wiring should only be carried out by qualified personnel.
To prevent electric shock, do not operate the amplifier with any of the conductor portion of the speaker wire exposed.
NOTE:
For reasons of safety and performance only use high-quality fully insulated speaker cables of stranded copper
wire. Use the largest wire size that is economically and physically practical. Make sure that the cables are not longer than
necessary.
LINUS5-C
3. INSTALLATION