11
After Sales Support
Telephone:
1300 663 907
Internet:
www.winplus.com.au
ArMEd MOdE / disArMEd MOdE / hOME MOdE
There are 3 modes available for the Cocoon Wireless Alarm System.
1. Armed Mode
All sensors are actively monitoring activity in your home.
Once a sensor is triggered, the alarm will sound.
1.
Press the
button to enter Armed Mode.
2.
After a short delay, all sensors will be armed.
3.
Once armed, if the sensors are triggered the alarm will activate.
Tip: see p. 25 for details on changing the Pir motion sensor time delays.
2. disarmed Mode
All wireless sensors in the system will be inactive except those operating in 24 hour mode.
Wired sensors (which operate in 24hr mode) will also remain active.
A.
Enter your PIN (Default: 1234) and press the
button to enter Disarm Mode. You
will hear 1 beep to indicate the password was correct.
B.
If you hear 2 beeps, your password is incorrect and you will need to enter it again.
C.
In disarm mode, you will deactivate all sensors in the system except those
operating in 24H mode.
Tip: see p.23 for information on setting operating modes for each sensor.
3.
home Mode
Door and window sensors will be armed and wireless PIR sensors will be disarmed when using the
default settings.
A.
Press the
button to enter Home Mode. In home mode, all sensors set to Normal
Mode will remain armed.
note: By default, door and window alarms are set to normal Mode while the Pir
motion sensors are set to home Mode. This allows you to move about your house freely
without activating motion detection alarms, however, if the door or window alarms are
triggered the alarm will be activated.
Tip: see p. 23 for details on changing the Pir motion sensor modes.
