Cobra cf4, Инструкция по установке и эксплуатации

Страница: 13 / 20

11
CORRECT LEVEL FOR FRYING MEDIUM WHEN AT
FRYING TEMPERATURE, KEEP TOPPED UP
INDICATES CORRECT FRYING MEDIUM LEVEL
WHEN COLD
Draining and Cleaning
Opening the Drain Valve
a. Lift the locking slide on valve handle (Fig 4) to
release valve.
b. While holding the locking slide in the
withdrawn position, rotate the handle
anticlockwise (Fig 5) to open the valve.
c. When the valve is closed, the locking slide will
drop down over the locking valve to prevent
accidental opening of the valve as shown in
Fig 4.
Daily Cleaning
1. At the end of each day / shift, if frying schedule
is heavy, frying medium should be drained and
strained into a receptacle.
2. Always filter the fryer when the cool zone under
the elements is hot and liquid.
3. Screw on the drain extension pipe and position a
suitable container and filter under the drain.
4. Carefully open the drain valve to minimise
splashing, and take care not to overfill the
container.
Part 5 Cleaning and Maintenance
General

To achieve the best results cleaning must be
regular and thorough and all controls and
mechanical parts checked and adjusted
periodically by a qualified service person. If any
small faults occur, have them attended to
promptly.

Don't wait until they cause a complete
breakdown. It is recommended that the
appliance is serviced every 6 months.

Clean the fryer regularly. A clean fryer looks
better, will last longer and will perform better.
NOTE:

DO NOT use abrasive detergents, sharp scrapers,
strong solvents or caustic detergents as they
could corrode or damage the fryer.

Ensure that any detergent or cleaning material
have been completely removed after each
cleaning.
To keep your fryer clean and operating at peak
efficiency, carry out the following procedures:-
C
AUTION
:
Always turn off the gas and electrical
supply at the mains supply before cleaning.
This appliance is not water proof.
Do not use water jet spray to clean interior
or exterior of this appliance.
WARNING:
DO NOT
USE FLAMMIBLE SOLVENTS AND CLEANING AIDS ON
OR IN CLOSE PROXIMITY TO THE FRYER WHILST THE FRYER IS STILL
HOT.
C
AUTION
:
Never drain the fryer with power or burners
‘ON’.
Always switch ‘OFF” the fryer before
draining or re-filling the tank.
WARNING:
DO
NOT ATTEMPT TO MOVE THE FRYER WHILST THE FRYER IS FULL
OF OIL
.
BEFORE ATTEMPTING TO MOVE THE FRYER
,
ENSURE THAT ALL THE OIL HAS BEEN DRAINED FROM
THE TANK
.
REFER TO THE INFORMATION BELOW ON
HOW TO DRAIN THE OIL FROM THE FRYER
.
Fig 4
Locking
Slide
WARNING:
H
OT OIL WILL BURN
-
DO NOT RUSH THIS JOB
.
Fig 5
Locking
Slide