COMPLETE INSTRUCTIONS
G100-G300
68
Il sistema conferma sempre il cambio di tabella tramite il lampeggio degli indicatori di
direzione: il numero dei lampeggi corrisponde al numero della tabella in cui vi trovate.
14.4
- How to enable/disable a G300 function.
After accessing the basic or advanced functions table, quick-press the control panel
button and place yourself on the line number corresponding to the function you want to
enable/disable. Short flashes will indicated that the function is disabled, slow flashes that
it is enabled. The number of flashes will be the same as that of the line in the functions
table that you have selected.
To enable/disable a function, keep the button on the control panel pressed down until the
frequency of the LED flashes change.
Several functions on the same page can be enabled at the same time. Enabling one
function does not automatically disable the others. Beside the tables, in which you will
find the programmable functions subdivided into buzzer, basic and advanced, the
programming procedure is shown in diagram form; this will be useful as a quick reminder
when carrying out the various phases.
When you have finished, close the vehicle’s bonnet and the system will signal by flashing
the direction arrows for 3 s that you have exited the programming procedure.
Beside the tables, in which you will find the programmable functions subdivided into
buzzer, basic and advanced, the programming procedure is shown in diagram form; this
will be useful as a quick reminder when carrying out the various phases.
15
-
PROCEDURE FOR ADDING NEW RADIOCONTROL DEVICES (G100)
ANDNEW DRIVER CARDS (G300).
G100
15.1
-Procedure for adding new radiocontrol devices (self-learning).
If the radiocontrol devices are lost or are not operating properly, it is possible to replace
them but only under secure conditions as this operation is only allowed in particular
circumstances. If you still possess at least one of the radiocontrol devices and it is
operating correctly, proceed as follows:
1.
Disarm the system.
2.
Open a door and the bonnet.
3.
Turn on the ignition.
4.
Keep button “A” on the radiocontrol device pressed down until the direction
indicators flash.
5.
Key in the PIN code.
6.
The system will confirm that you have accessed the self-learning procedure by
another long flash of the direction indicators and by lighting up the system LED
with a steady light.
7.
Press key “A” on the radiocontrol, checking that the radiocontrol LED flashes and
that the LED on the emergency panel stops shining for approximately 1 s; the
direction indicators will also give a short flash to confirm that the radiocontrol
device has been recorded in the system’s memory.
8.
Repeat step 7 for all the radiocontrol devices that you want to enable (the
06DE2373Acorrect version.pmd
16/03/2007, 11.07
68