COMPLETE INSTRUCTIONS
G100-G300
67
14
- HOW TO PROGRAMME THE SYSTEM.
G100
14.1
- Programmation.
To access the programming function, the system must be disarmed, the door and
bonnet must be open and the ignition must be turned on (+15 present). Press
radiocontrol button “A” and keep it pressed down: if all the necessary conditions are
present the LED on the control panel will light up and after about 3 s the system will
respond by flashing the direction arrows to indicate that you have entered the programming
function and are in the buzzer table (buzzer volume adjustment).
Press radiocontrol button “A” to raise the buzzer volume, press radiocontrol button
“B” to lower it.
To proceed onwards to the next table, turn the ignition key to OFF position then to ON.
Il sistema conferma sempre il cambio di tabella tramite il lampeggio degli indicatori di
direzione: il numero dei lampeggi corrisponde al numero della tabella in cui vi trovate. This
signal will be emitted about every 10 s to remind you of the number of the page where you
are positioned.
14.2
- How to enable/disable a (G100) function.
After accessing one of the tables, press radiocontrol button “A” and position yourself
on the line number corresponding to the function you want to enable/disable. Fast
flashing will indicate that the function is disabled,
invece
slow flashing that it is enabled.
The number o
f flashes will be the same as that of the line in the functions table that you
have selected. To enable/disable a function, press radiocontrol button “B”.
Several functions on the same page can be enabled at the same time. Enabling one
function does not automatically disable the others.
G300
14.3
- Programmation.
To access the programming function, the system must be disarmed, the door and bonnet
must be open and the ignition must be turned on (+15 present). Key in the PIN code, if
all the necessary conditions are present the LED on the control panel will light up and
after about 3 s the system will respond by flashing the direction arrows twice to indicate
that you have entered the programming function and are in the buzzer table (buzzer
volume adjustment). To lower the buzzer volume, push the button on the control pannel,
giving it a series of slow presses. At each press, you will hear the buzzer volume
decrease.
To raise the volume, make the series of presses by pushing the button fast. At each
press you will hear the buzzer volume increase.
To proceed onwards to the next table, turn the ignition key to OFF position then to ON. The
system will respond with three flashes of the arrows to indicate that you are in the basic
functions table; this signal will be emitted about every 10 s to remind you of the number
of the table in which you are located.
The system will again confirm the change of table by flashing the direction indicators.
To
proceed onwards to the next table, turn the ignition key to OFF position then to ON.
06DE2373Acorrect version.pmd
16/03/2007, 11.07
67