COBHAM Sea Tel 09 Series, Процедура обновления

Страница: 8 / 64

Upgrade Procedure, xx09 MK2
Page 8 of 64
Document No
132622 Rev B
Form # 117140-B
1.1.8.
Connect all the cables to the MK2 PCU.
MK2 PCU connections
1. Connect the Orange mini coax (this
is the Cross-Pol coax which will
route to the LNB on the feed) SMA
connector to the “NC J1” port on
the MK2 PCU.
2. Install the 113303-10 black jumper
coax from the “COM J3” port on the
MK2 PCU to the “L-Band” port on
the MK2 PCU
3. Connect the Yellow mini coax (this
is the Co-Pol coax which will route
to opposite side of the antenna and
connect to the Co-Pol LNB OR be
terminated with an F bullet and tied
in place near the BUC) SMA
connector to the “NO J2” port on
the MK2 PCU.
4. Install adapter pigtail to the “Feed”
port on the MK2 PCU.
5. Install the “RX” coax to the “Rotary
Joint” port on the MK2 PCU.
6. Install the “RF M&C” cable to the
“RF M&C” port on the MK2 PCU. If
your harness has a female M&C
connector, you will need to install
the 9-pin gender changer (in the
upgrade kit), to enable you to plug
the harness into the RF M&C port.