COBHAM Sea Tel 09 Series, Процедура обновления

Страница: 13 / 64

Upgrade Procedure, xx09 MK2
Page 13 of 64
Document No
132622 Rev B
Form # 117140-B
3. Using the 10mm open end wrench,
remove the 4 10mm nuts (two on
top and two on the bottom of the
MDE) that mount the MDE to the
pedestal.
4. Remove the original MDE.
5. Apply loctite 242 to the four
threaded mounting bolts and
mount the MK2 MDE using the four
nuts removed in the previous step.
6. Reinstall the 5 connectors, one at a
time, using the small flat blade
screwdriver to secure the retainer
screws.
7. Install two 122782 push-in cable
ties by pressing the pointed end
into the vacant holes on the side of
the MDE and secure the home and
AZ cables to the MDE.
8. Install a 7” cable tie to secure the
TX & RX coaxes to the Home & AZ
cables.
9. Trim the excess length off of ALL
cable ties installed during this
upgrade.
1.1.11. Check PCU connections
WARNING:
Verify that the “
Service
” and “
USB
” ports on the MK2 PCU are
VACANT
prior to applying AC power to the antenna.
1.1.12.
Change the course counter balance weight configuration:
Standard weight configurations
1. Find the course balance weight kit for your specific model-dash number in the table below.
2. Remove the weights shown on the current configuration drawing. Combine these weights
together with the counter weights provided in this upgrade kit.
3. Install the weights shown on the MK2 configuration drawing to course balance your upgraded
antenna..