COBHAM Sea Tel 09 Series, Процедура обновления

Страница: 2 / 64

Upgrade Procedure, xx09 MK2
Page 2 of 64
Document No
132622 Rev B
Form # 117140-B
1.1. Upgrade Procedure, xx09 MK2 electronics
Upgrading an 09 Pedestal to MK2 electronics can be accomplished using the 132196 Upgrade Kit and the following
procedure. Please read this entire procedure before beginning work.
1.1.1.
Refer to the upgrade kit Bills Of Materials (BOM) at the end of this procedure. Make sure that you inventory
the BOM for the 132624-1 BALANCE WEIGHTS, xx09, MK2 that is included in the upgrade kit.
Inventory the 132196 Upgrade Kit
1.1.2.
Screw Driver, Flat Blade, Small (1/8” blade)
Tools Required:
Screw Driver, Phillips, Small (#1)
Diagonal Cutters
Wrench, Open End, 5/16” (8mm)
Wrench, Open End, 10mm
Wrench, Open End, 7/16” (11mm)
Wrench, Allen, 3/16” (5mm)
Lint free cloth with a small amount of acetone
Felt tip marker
1.1.3.
Dangerous voltages exist on the antenna pedestal, assure that power is secured at the antenna pedestal
breaker BEFORE commencing work.
Cautions and Warnings
While working inside the radome be cautious of pinch hazards in the area of the azimuth chain, the
elevation belt and the cross-level belt.
WARNING:
Electrical Hazard – Dangerous AC Voltages exist on the
pedestal. Secure power at the Antenna Pedestal Breaker Box. Observe
proper safety precautions when working on the antenna pedestal inside the
radome.
CAUTION - PINCH HAZARD
: Use extreme caution when your fingers are
near the chain drive system of this antenna, even when antenna power is
turned OFF.
Do not put your fingers in between the chain and either sprocket.
CAUTION - PINCH HAZARD
: Use extreme caution when your fingers are
near the belt drive systems of this antenna, even when antenna power is
turned OFF.
Do not put your fingers in between the belt and either sprocket.