Cobalt Digital Inc 1999 190, Руководство пользователя

Страница: 87 / 96

202/203
CS
M
ODEL
S
PECIFIC
I
NFORMATION
12. Circuit Breakers - Push to reset if necessary. If the button continues to pop out
consult your Authorized Cobalt Dealer.
13. Horn Button - The horn, itself, is located under the deck.
SHOULD WATER TEMPERATURE REACH 180 DEGREES FAHRENHEIT, YOUR ENGINE
IS OVERHEATING AND SHOULD BE CHECKED IMMEDIATELY FOR PROBABLE CAUSE.
NEVER OPERATE YOUR BOAT AT NIGHT WITHOUT ALL OF THE REQUIRED LIGHTS
OPERATING. (THIS INCLUDES BOW LIGHT AND REMOVABLE STERN LIGHT.)
DO NOT USE BOARDING LADDER WHILE ENGINE IS RUNNING. CAUTION: THE
STERN DRIVE UNIT HAS MANY SHARP EDGES, ESPECIALLY THE PROPELLER. EXERCISE CAUTION
WHEN NEAR THE STERN DRIVE UNIT.
S
WIM
P
LATFORM
The swim platform cannot be jumped on. Jumping on the swim platform can be
dangerous and can also cause damage to the mounting brackets.
MAKE SURE THE ENGINE IS SHUT OFF BEFORE USING SWIM PLATFORM.
S
HAFT
A
LIGNMENT
The alignment of the transmission and propeller shaft is factory set to within a
maximum of 0.003 inches. Noise and vibration will result if the transmission and
propeller shaft become mis-aligned. This alignment must be checked annually. Please
consult your Cobalt Dealer for further information.
P
ACKING
S
EAL
A packing seal, located where the propeller shaft passes through the hull bottom, keeps
water from entering the boat. During the first two-three hours of your new Cobalt’s
operating life, the seal should be allowed to drip water inside the hull at a rate of one
drip per second (with the shaft turning). After the break in period, adjustment of this
packing seal may be necessary. Please consult your Cobalt Dealer for further
information. The packing seal must be checked annually.
Always allow the packing seal to drip a slight amount for lubrication purposes.
CS.3