Cobalt Digital Inc 1999 190, Руководство пользователя

Страница: 17 / 96

IV
13
C
OBALT
B
OATS
- O
WNER
’
S
M
ANUAL
23LS/25LS/293
1. Bimini top is stored in the upright position for both trailering and storage.
2. Open top and extend the telescoping legs by depressing the buttons protruding
through the sides of the legs.
3. Install support leg ends to the appropriate mounting brackets on the deck or
windshield.
4. Pull on the forward edge of the top to telescope the legs closed for tight canvas fit.
Due to the length of the bows, there is no storage provided on some models. Storage is provided
on all but the 206, 226, 23LS, 25LS, and 293 models.
If the canvas was stored when wet, it may have shrunk slightly making it hard to pull tight. If this
happens, two people may have to pull at the same time to close the support legs.
THE BIMINI TOP MAY BE SUSCEPTIBLE TO DAMAGE FROM WIND VELOCITY IN
EXCESS OF 35 MPH. DAMAGE COULD OCCUR RESULTING IN POSSIBLE INJURY TO THE
OCCUPANTS OF THE BOAT.
B
OW
T
ONNEAU
C
OVER
-
OPTIONAL
(
BOWRIDERS ONLY
)
1. Open walk-thru doors.
2. Starting at bow and working aft, snap
cover to boat.
3. Close windshield center door and snap the
canvas to the underside of the door.
4. Install the adjustable tonneau cover pole
adjust to “tent” the cover.
5. Walk-thru doors may be closed if desired.
C
OCKPIT
T
ONNEAU
C
OVER
-
OPTIONAL
1. Unroll cover and snap to the deck starting at the center of the windshield. Snap to
the forward outside edge of the windshield only.
2. Install tonneau support pole to underside of cover (just in front of rear seat) with
snap and adjust pole to approximate height of windshield. Some models have two
support poles.
3. Snap aft end of cover to back deck starting in center and working outboard (note:
you may have to readjust the support pole for proper fit).
4. Continue snapping up sides.
B
OAT
O
PERATION
COBALT