35
OWNER’S MANUAL
2017
REMOVING YOUR COAST SPA PANEL TO ACCESS EQUIP-
MENT
1. Start by removing the three screws at the bottom of the panel
(Illustration 1). These screws will be covered with a cap. To remove
the cap, use a flat head screw driver on the bottom edge of the cap.
Place the screw driver between the cap and the spa and simply
twist screw driver to remove cap. Using a Robertson tip screw
driver, remove the three screws.
2. After removing the three screws, grasp bottom outer edges of
the panel and pull firmly towards your body to release the Panel
Clips. Ensure not to pull too hard as you could potentially break the
clips (Illustration 2).
3. After releasing the clips, lower the panel to the ground. If your
Spa is equipped with an Obsidian Display, there will be three wires
to disconnect (Illustration 3).
RE-INSTALLING THE PANEL
1. Hold the bottom edge of the panel and insert the top edge
under the lip of the spa. Center and align horizontally with the Spa
to position the Clips.
2. Once aligned, apply pressure to both sides of the panel re-
securing the clips. This does not require a lot of pressure and
should click together easily.
PANEL REMOVAL INSTRUCTIONS
Illustration 1
Illustration 2
Illustration 3
