17
COAST CLASSIC SERIES TOPSIDE CONTROLS
NITIAL START-UP
Your spa will enter Priming Mode (PR) when it is energized. During
Priming Mode, press “Jets” button repeatedly and be sure the pump is
free of air. Priming Mode lasts less than 5 minutes. Press “Warm” or
“Cool” to exit. After Priming Mode, the spa will run in Standard Mode
(see Mode section).
TEMP CONTROL (80°F - 104°F / 26°C - 40°C)
The last measured water temperature is constantly displayed. The water
temperature displayed is current only when the pump has been running
for at least 1 minute. To display the set temperature, press “Temp” once.
To change the set temperature, press the temperature button again
before the display stops flashing and hold. The set temperature will be-
gin to rise, release the button at the desired set temperature. To de-
crease the set temperature, press and hold the “temp” button again and
the set temperature will decline, release at the desired set temperature..
After three seconds, the display will stop flashing and begin to display
the current spa temperature. The spa will then begin heating (or cool-
ing) in order to reach the set temperature that you have selected.
PUMP
Press “Pump” to turn the pump on or off, and to shift between low and
high speeds (if equipped). If left running, the pump will turn off after a
preset length of time. Low speed may run automatically at times as part
of your spas filtration cycles, during which it cannot be deactivated from
the panel, however you will still be able to control the high speed setting.
The ozone generator (if installed) will activate anytime low speed is run-
ning.
AUX (PUMP 2)
If an additional pump or blower is installed. Press “Aux” to turn the de-
vice on. If your additional device is a dual speed pump, pressing “Aux”
OWNER’S MANUAL
2017
again will activate the pumps high speed. Pressing “Aux” again will turn
off the device/pump.
LIGHT
Press “Light” to operate the spa light. Turns off after 4 hours. If your hot
tub is equipped with a multicolor lighting package, then pressing the
“Light” button consecutively will toggle the lights through different colors
modes.
MODE
Mode is changed by pressing “Temp” then “Light’. Pressing the “Temp”
button to toggle through the available modes. Press “Light” to exit pro-
gramming.
Standard Mode
maintains set temperatures. “St” will be displayed mo-
mentarily when you switch into Standard Mode.
Economy Mode
heats the spa to the set temperature only during filter
cycles. “Ec” will display when the water temp is not current, and will alter-
nate with water temp when the pump is running.
Sleep Mode
heats the spa to within 20°F/10°C of the set temperature
only during filter cycles. “SL” will display when water temp is not current.
And will alternate with water temp when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the spa is energized.
The second preset filter cycle begins 12 hours later. Filter duration is
programmable for 2,4,6, and 8 hours or “C” (continuous). The default
filter time is 2 hours. To program, press “Temp” then “Pump”. Press
“
Temp” to adjust. Press “Pump” to exit programming.
