O P E R A T I N G M A N U A L
8 0 0 . 7 4 9 . 2 7 6 1
w w w . c o a c h c o m m . c o m
6 6
5. Mount the RT mounting bracket(s) to the top of the mast using the provided pins.
6. Connect the RT cable to the first RT on the top bracket.(See Figure 92.)
Note:
If using a second RT bracket, also connect the RT cable to the first RT on the bottom bracket.
CAUTION:
Failure to connect the RT cable in the correct port can lead to system configuration errors.
7. Attach the cable’s strain relief to the eye bolt on the mounting bracket.
8. Bend the antennas so they are parallel to the ground (90° angle between the antenna and the RT) and point their
tips toward the opposing team’s RT mast.
9. Carefully walk the mast up until the receiving tube is upright and flush with the Cart and secure with pins 2 and 3
(which you removed in step 3).
Connecting One RT Cable
For customers with only one RT rack, mount the rack to the highest point on the mast and connect only one of the RT
cables in the bundle from the Cart’s rear patch panel. (You may use either red or blue, as long as the same color is plugged
into the TOP RT SET port in the Cart’s rear patch panel. You should NOT use both red and blue ends with a single RT rack
setup.)
The RT cable from the cart’s rear patch panel connects to the X-NET IN port of the first RT.
IMPORTANT:
DO NOT connect this cable to an RT LOOP port.
Figure 92: RT Cable Connection Location
