EVAC-500 Voice Alarm & Evacuation System Operation Manual
33
/
42
“Firmware download” is used to replace the firmware of voice alarm controller. Please take care in this operation
(please refer to the upgrading part of voice alarm controller firmware); ”Network adapter” is used to modify the
reference of host network, which shall be kept consistent with the current network of the user;
“Empty all log” is used to delete all status records or logs of host system modules (please take care in operations,
and please refer to the following chapters LOG);
“Software Security” is used to enhance the operation security, namely, the security authentication as the user
exits. If it is “checked”, it is necessary to enter the password as the user exits the software.
4) “HELP” menu
is used mainly to view the software version.
6.3.3. Control Menu:
General:
“CONTROL” with the right voice control button is to control output status of system zone, these
included group configuration, appoint EVAC-500 host or EVAC-500 extension host ‘s single zone output control.
1.
“STATE
” is for checking the working status of system’s device module.
2.
“SYSTEM CONFIGURATION
” for check or modify the working device data in current system
3.
“LOG”
is for checking data record of system device and module.
4.
“OTHER”
is for modify the user’s login password, correct the time of EVAC-500 host and modify the speaker
impedance error of EVAC-500 system, the percentage more larger means accuracy is more lower.
6.3.4. Zone Control Configuration
Login software or click the left “CONTROL” as (picture 1) above, it shows message as below
:
In the left shows that they are six group in EVAC-500SF
On the right shows that they are six zone in current system.
The red LED on the top of right indicate current system worked at emergency model
The yellow LED shows that is fault with the current system module.
The red and yellow of EVAC voice button LED off means that EVAC voice message is OK in the current
SD card
Description:
On the left hand is EVAC-500 or EVAC-500RT panel line output control knob, EVAC-500SF’s just
shows current effective line output
EVAC-500SFT’s system group can be set from 0~120, via“”system configuration”-“Equipment parameter”
to confirm the group number(default is six),each zone in the group can set via “Group”
Put the mouse to the empty place of grouping list and double click or press “
” to show all zone
status
Please click group items in group list to check zones include the group, such as click group six
Show as below:
In above picture, the blue background in left hand means is chosen, in the right hand shows that there are six zone
in this group. You can add or delete more zone of host or extension host. After modify please make sure to click
“Application” after modify)
①
The red LED on the top right can only reset via the red EMERGENCY button on the front panel of
EVAC-500 or “3-Emergency Reset Input” in rear panel, user can use EVAC 500SF to control the active of EVAC
