EVAC-500 Voice Alarm & Evacuation System Operation Manual
26
/
42
"1" -> "2" (configure the system to allow the number of remote MIC: the value of EVAC-500TP, EVAC-RM and
EVAC-500FM sum).
-> "3" (configure the type of MIC, EVAC-500TP and EVAC-RM "TYPE" select "Business paging").
-> "4" (select the "Paging" index number for the current working parameter configuration).
-> "5" (used to select the corresponding paging key number, the picture shows the first button).
-> "6" (for the current button to take an alias for easy memory recognition, up to 12 valid characters, can be
automatically displayed in the EVAC-500TP interface, EVAC-RM need to use their own printed note mark).
-> "7" (used to set the working mode, when the "Paging mode" for the constituency, press only said that the selected
group, do not perform other functions, the figure set to "BGM play" that control the host built-in background Music and
lines into the specified partition, including the expansion of the main partition, press to open, press again to close)
-> "8" (for selecting whether to output built-in background music or external input line audio).
> "9" (when "8" select "Built-in music" to further specify the play of the track).
-> "10" (for selecting the output partition, including the extended host).
-> "11" (for the device built-in background music playback mode, currently only supports single loop and all files in this
folder loop).
According to the diagram above "1 ~ 11" after configuration is complete, please click on the "12", in the Address for the
EVAC 01-500 FM the need to "Address the assignment)." - > "TYPE" - > "Fire the paging" ", the EVAC - RM "by default"
Business the paging "" or EVAC - 500 tp to press the button" 01 "can be the host of the built-in SD card in the BGM song
play 1 to" host 01 line 02 with the input signal is detected, the automatic line audio 02 output to the above, the output of
the "3" configuration partition, namely host 1 ~ 6 partition again press, closed the current output.
5.6.1. Via Software EVAC-500SFT BGM Broadcast
（
1
）
. Manual BGM Broadcast:
i.
Click on the corresponding zone name, when a rectangle button appears, click to open or close the zone
of the corresponding host as shown below:
Note
：
This operation only opens the zone of the corresponding host, not audio processing. If there is audio
output at present, the audio can be exported without the audio output, namely, open and no audio output
.
ii. Click on the audio on the right, and the current LED is lit, which means open, as shown below:
Note
：
This operation only opens the host audio, does not automatically open the output partition, and operates
on the corresponding host panel.
（
2
）
. Specify grouping and audio output
:
i.
You should configure the grouping by the following figure
:
