Issue 6 31/1/14 - CMS Marine - +44 (0) 1452 380100 – [email protected]
Page 9
Fitting – Control Unit
Using the template provided in your installation kit, carefully make pilot holes using a 2mm drill bit.
Using the x4 screw provided, mount the control box to your chosen location.
NOTE : When drilling / screwing into boat surfaces check that there are no cables or pipes on the opposite
side of the surface. Check that once installed the screws will not protrude through the surface.
Remember that you should ensure that the control box is mounted above the waterline.
PLEASE ENSURE YOU HAVE ACCESS TO THE UNDERSIDE OF YOUR CONTROL UNIT TO ALLOW FITMENT OF
THE CONNECTORS.
Fitting – Transducer Cables
The transducer cables supplied are made from marine based silicon and will withstand any water or
temperature fluctuations during normal operation.
It is suggested that where possible you follow any current cabling or trunking to aid your installation of
cables.
Starting at your transducer work the cable back to control unit.
DO NOT CONNECT ANY OF THE CABLES TO YOUR UNIT AT THIS STAGE.
DO NOT COIL ANY TIGHTLY UNUSED CABLE, LARGE LOOSE COILS ARE OK.
IF YOU REQUIRE LONGER CABLES TO REACH YOUR CONTROL UNIT PLEASE CONTACT US FOR EXTENSION
CABLES
If you need to drill through any watertight bulk heads or lockers ensure you use a cable gland to ensure
they remain watertight. If you require any support or advice at this stage please contact our technical team
who will be more than happy to offer some advice.
Содержание SonicSheild III
Страница 1: ...Issue 6...
