Club Car TURF 2 XRT, Руководство пользователя

Страница: 39 / 44

2001 Turf 2 XRT Gasoline Vehicle Owner’s Manual 37
WHEEL AND TIRE INSTALLATION
NOTE: Upon vehicle delivery, the shipping wheel and tire assemblies must be replaced by the standard Turf
2 XRT wheel and tire assemblies, which are delivered in the vehicle cargo bed.
Do not remove the warning tag attached to the steering wheel until the shipping wheel and tire
assemblies have been replaced by standard Turf 2 XRT wheel and tire assemblies.
Unlike some other vehicles, the Turf 2 XRT’s front and rear wheels are NOT interchangeable. The rear
wheels have a different offset than do the front wheels; The rear wheels must be installed with the deeper off-
set facing out.
A rectangular sticker on each wheel designates its correct location on the vehicle.
LF —Left Front (driver side)
RF—Right Front (passenger side)
LR—Left Rear
RR—Right Rear
Standard Turf 2 XRT tires (off-road) are directional and must be installed according to the directional arrow
mark on each tire, (arrow must indicate forward rotation of tire) or tread performance will be severely compro-
mised. The optional turf tire is not directional, and installation is dictated only by correct wheel position, not tire
direction.
1. Slightly loosen the lug nuts on all four wheels.
2. Raise one end of the vehicle until the tires are off the ground by approximately 15.2 cm (six inches).
See following WARNING.
∆ WARNING
• Lift only one end of a vehicle at a time. Before lifting, set the park brake when lifting the front
of the vehicle, unload the cargo bed, and chock the wheels that remain on the floor. Use a
suitable lifting device (chain hoist or hydraulic floor jack) with 454 kg (1000 lb.) minimum
lifting capacity. Do not use lifting device to hold vehicle in raised position. Use approved jack
stands of proper weight capacity to support vehicle.
3. Remove the lug nuts and the wheel.
4. Install the correct wheel and tire assembly and tighten lug nuts (using a crisscross pattern) until they
are snug. Arrow must indicate forward rotation of tire.
5. Repeat steps 3 and 4 for the other side of the vehicle.
6. Lower the vehicle to the ground and finish tightening lug nuts (using a crisscross pattern) to 74.6 N·m
(55 ft-lb.).
7. Repeat steps 2-6 for the other end of the vehicle.