Club Car TURF 2 XRT, Руководство пользователя

Страница: 30 / 44

Battery
28 2001 Turf 2 XRT Gasoline Vehicle Owner’s Manual
3.5. Plug the fuel tank vent nipple so that it is air tight. We recommend using a slip-on vinyl cap.
3.6. Disconnect the battery, negative (–) cable first (Figure 2, Page 15).
4. To protect the engine, remove spark plug and pour 14.8 mL (1/2 ounce) of SAE 10 weight oil into the
engine through the spark plug hole. Rotate engine crankshaft by hand several times and then re-install
the spark plug.
5. Inflate tires to rated capacities. See Vehicle Specifications on page 6.
6. Grease front suspension and do all other semiannual periodic lubrication. See Periodic Lubrication
Schedule on page 31.
7. Thoroughly clean body, seats, cargo bed, engine compartment, and underside of vehicle.
8. Do not engage the park brake. Block tires to prevent the vehicle from rolling
TO RETURN THE STORED VEHICLE TO SERVICE
1. Connect the battery, positive (+) cable first.
2. Restore fuel system to operation.
2.1. Remove plug from the fuel tank vent nipple and open the fuel shut-off valve (Figure 14, Page 27).
Make sure the valve is fully open. A partially closed fuel shut-off valve (Figure 15, Page 27) com-
bined with the use of the choke, can result in a fouled spark plug and engine failure.
2.2. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped
into the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE.
NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a
short while when running it for the first time after storage.
3. Readjust tire pressure. See Vehicle Specifications on page 6.
4. Perform the Pre-Operation and Daily Safety Checklist on page 22.
BATTERY
Read DANGER and WARNING on page 14.
The battery in a Club Car gasoline vehicle is a 12-volt, low-maintenance battery that requires infrequent
watering (Figure 16, Page 29).
Any corrosion around the positive (+) or negative (–) terminals should be washed off with a solution of baking
soda and water (237 mL (1 cup) per 3.8 L (one gallon) of water) and then the baking soda solution rinsed off
the battery. Do not allow the solution to get into the battery. Be sure terminals are tight. Let the terminals dry
and then spray them with Club Car Battery Terminal Spray (CCI 1014305). See following CAUTION.
∆ CAUTION
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do
so may cause them to overheat during operation.