Club Car DS Villager 4, Руководство по техническому обслуживанию и ремонту

Страница: 472 / 510

24
Shifter Cable GASOLINE VEHICLE - TRANSAXLE
3. Push the cable end socket (1) off the stud (3) on the Forward/Neutral/Reverse shifter handle (Figure 24-15,
Page 24-14) .
4. Press in tangs (4) anchoring shifter cable (2) to chassis and push out of mounting hole.
5. Loosen jam nuts (1) securing shifter cable (2) to FNR/accelerator cable bracket (3) (Figure 24-16, Page 24-14) .
Then, remove bowtie clip (3) to disconnect shifter cable end (4) from transaxle shift lever (5).
6. Cut wire ties securing shifter cable to chassis.
7. Make note of cable routing, then remove shifter cable from vehicle.
2
3
1
4
4
2
3
5
1
3064
Figure 24-15 Shifter Cable at FNR Handle
3133
Figure 24-16 Shifter Cable at Transaxle
SHIFTER CABLE INSTALLATION
1. Install shifter cable (2), routing it exactly as it was originally, from Forward/Neutral/Reverse shifter handle
to transaxle.
2. Place rear of cable (2) in FNR/accelerator cable bracket with a jam nut (1) on each side of bracket (Figure 24-16,
Page 24-14) . Tighten jam nuts (1) to 22 lb·ft (29.8 N·m).
3. Hook shifter cable end (4) into transaxle shift lever (5) and secure with bowtie clip (3).
4. Feed front of cable (2) through its mounting hole and push the plastic anchor into hole until tangs (4) snap
into place
(Figure 24-15, Page 24-14) .
5. Snap cable end socket (1) onto stud (3) of Forward/Neutral/Reverse shifter handle.
6. Secure shifter cable along chassis with wire ties if required.
7. Connect battery and spark plug wire.
See Connect the Battery - Gasoline Vehicles on page 1-4.
SHIFTER CABLE ADJUSTMENT
Cable is properly adjusted when both the Forward/Neutral/Reverse handle and shift lever on transaxle are in the
NEUTRAL position at the same time.
Page 24-14 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual