Club Car DS Villager 4, Руководство по техническому обслуживанию и ремонту

Страница: 199 / 510

CONTROLLER DIAGNOSTIC TOOL (CDT) Diagnostics Menu
11
FAULT RECOVERY
When a fault is detected by the controller, the controller will attempt to recover from the fault and resume normal
operation. In the case of an intermittent problem, such as a loose wiring connection, the controller
may be able to
recover and operate normally for a while, but the problem should be repaired before placing the vehicle in service.
Depending on the type of fault, the controller will attempt to recover either immediately after the condition clears or
after the accelerator pedal has been cycled (released and pressed again).
_
CONTROLLER FAULT
CONTROLLER ATTEMPTS TO
RECOVER...
HW FAILSAFE When key switch is cycled
THROTTLE FAULT When condition clears
SPEED SENSOR When condition clears
MAIN WELDED When condition clears
MAIN DRIVER ON When condition clears
MAIN DRIVER OFF When accel. pedal is cycled
MAIN COIL OPEN When accel. pedal is cycled
FIELD MISSING When accel. pedal is cycled
HPD When accel. pedal is cycled
OVERVOLTAGE When condition clears
LOW BATTERY VOLTAGE When condition clears
THERMAL CUTBACK When condition clears
MOTOR STALL When condition clears
MAIN DROPOUT (1 and 2) When accel. pedal is cycled
MAX PASSWORD TRIES When Tow/Run switch is cycled
INCORRECT PASSWORD When Tow/Run switch is cycled
MAIN DRIVER OVERCURRENT When condition clears
CURRENT SENSE FAULT Within controller
M– SHORTED When key switch is cycled
ANTI-TAMPER When condition clears
HIGH SPEED WALKAWAY When condition clears
LOCKOUT FAULT When condition clears
LOW SOC When condition clears
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 11-17