Club Car 1995 Golf Car, Дополнение к руководству по обслуживанию

Страница: 37 / 100

4. Unplug the three No. 18 wires plugged into the controller (Figure 17-16).
5. Remove the four 7/16 lock nuts holding the controller (Figure 17-16).
6. Remove the controller from the vehicle.
Installing the Solid State Speed Controller:
Install in reverse order of disassembly.
CHARGER RECEPTACLE
Testing the Charger Receptacle:
See Section 19, See Test Procedure 1, Page 19-13
Removing the Receptacle (Figure 17-17):
1. Remove the No. 10 red wire (4) from the positive post of battery No. 1, and then pull the No. 10 red wire
to the receptacle (2) (Figure 17-17).
2. Locate the 1/4” “quick disconnect” terminal on the No. 10 grey wire from the charger receptacle.
Disconnect the No. 10 grey wire (3) at this terminal, leaving the sense lead fuse (1) attached to the grey
wire from the on-board computer (Figure 17-17).
3. Remove the No. 10 black wire (5) from the charger receptacle using a ratchet and a 3/8” socket.
4. Use a phillips screwdriver to remove the four screws (9) from the bezel (7), and the three screws (12)
from receptacle (2).
17-35
4
1
2
3
5
6
7
8
9
11
10
D.C. CORDSET
SEAT SUPPORT
FRONT PANEL
12
FIGURE 17-17