Club Car 1995 Golf Car, Дополнение к руководству по обслуживанию

Страница: 30 / 100

F&R Limit Switches Continued:
Installing limit switches:
Install in reverse order of disassembly. Insert labeled wires on the common (COM) terminal and labeled wires
on the normally open (NO) terminal of each switch. Torque screws to 5 in.lbs. (0.6 N-m). (If wires were not
labeled during removal, see Figure 17-2, Page 17-3, or Figure 17-3, Page 17-4 for proper wiring.)
After installation, be sure that when the rotor is turned, the lever arm of each switch is pressed and released
per chart above. If not correct, inspect the F&R rotor and limit switches for damage.
HALF-SPEED RESISTOR - ( TO HALF-SPEED REVERSE LIMIT SWITCH)
The half-speed resistor assembly is connected to the half-speed reverse limit switch on the F&R switch
(Figure 17-14).
17-28
FIGURE 17-14
1
3
4
5
6
7
8
9
SEAT SUPPORT
FRONT PANEL
F&R ANTI-ARCING LIMIT SWITCH
REVERSE BUZZER LIMIT SWITCH
REVERSE HALF-SPEED LIMIT SWITCH
F&R Lever Position
Limit Switch Forward Reverse
F&R Anti-arcing Depressed Depressed
Half-speed Reverse Released Depressed
Reverse Buzzer Released Depressed