CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com
- 3 -
- 4 -
CLS REVO Basic / Modular / Retail
Protection from burns and fire
• Provide a clearance of at least 50mm around the unit.
• Do not install this product near a heat source.
• Do not install this product in a corrosive, flammable or explosive area.
• Do not modify this product, or install other than genuine parts.
• Do not operate this product if the ambient temperature exceeds 40 ºC.
• Do not stare into the LED, this can cause damage to the eyes.
Protection from injury due to falls
• Verify that all covers and mounting hardware are securely fastened.
• Block the access below the work area whenever installing or removing the unit.
Note: It is important to read this manual before you install this product.
SAFETY INFORMATION
Warning! This product is for professional use only, not for domestic use.
Read this manual before powering up or installing the CLS REVO. Follow the instructions
listed below and observe all warnings in this manual.
Protection from electric shock
• Disconnect the power supply from AC power before installing, dismounting or maintaining the unit.
• Make sure all connectors are connected properly.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
• Refer all service to a qualified technician.
Installation REVO Basic
ATTENTION!
ThE CLS REVO IS AN IP67 OuTdOOR uNIT, buT CAN uNdER NO
CIRCumSTANCES bE uSEd uNdER wATER!
ThE wARRANTy ON ThESE ARmATuRES fOR OuTdOOR uSE, ONLy
APPLIES wITh A CORRECT uSE Of ThE CLS mOLd SET
(ARTICLE NO. 871992).
W
ARNING
1
2
3
4
1. The CLS Revo can be installed by using the mounting hole. Drill a hole to secure it in the wall, floor,
ceiling, etc. Drill a second hole for the power wire.
2. Adjust the CLS Revo to the preferred position by turning the unit towards or away from the wall.
3. Put the power wire in the earth socket.
4. The CLS Revo is ready to use.
