HCS QUAD PEDESTAL KIT INSTALLATION GUIDE
ClipperCreek
,
Inc.
Page 13
7. Install the HCS Quad EVSE Mounting Plates
An EVSE mounting plate is affixed to the front of the pedestal
post to provide flat and rigid base on which the EVSEs can be
mounted. In the case of a Quad-Mount installation, a second
mounting plate is affixed to the opposite side of the pedestal post.
• Hold the HCS Quad EVSE mounting plate against the front
side of the pedestal post as shown in
Figure 10.
• Align the two center screw holes of the mounting plate with
the corresponding top threaded inserts on the front of the
pedestal post.
• Secure the mounting plate to the pedestal with two (2)
1/4-20 x 3/4” Torx flat-head tapered screw using a T27 Torx
driver. Tighten until the head of the screw is flush with the
surface of the mounting plate
• Repeat on the opposite side with the second mounting plate,
making sure to nest the slots on the inside. See
Figure 11
.
• Place a #8 washer around the shaft of each of the (14) 8-32
pan head screws.
• Use six of the #8 screw and washer sets to secure the sides
of the Quad Mounting Plate as shown in
Figure 12
.
Figure 10: The EVSE Mounting Plates
Slide together
until holes align
Slot nests
on inside
(the inner
PEM nuts
slide into
slots)
Figure 11: Slide EVSE Mounting Plates Together
INITIAL PEDESTAL INSTALLATION (continued)
Figure 12: Secure Sides of Quad
Mounting Plates
