HCS Optional Features User Manual
16
Share2 Wiring Instructions: 8 and 10 Wire Harnesses
Follow the Wiring Diagram in
Figure 6
for proper wiring of a
Share2 that utilizes an 8 or 10 wire harness. Wiring connections
can be made in a junction box or pedestal body.
Strip the Blue,
Brown and White wires ONLY.
Use wire nuts (not included) to
secure the Blue and Brown wires to the opposing White wire as
indicated by the black dots in
Figure 6
.
Do Not Connect Wires marked with an “X”
X
BLACK
YELLOW
ORANGE
RED
GREEN
(GROUND)
BLACK
YELLOW
ORANGE
RED
GREEN
(GROUND)
X
X
X
X
BLUE
BROWN
WHITE
BLUE
BROWN
WHITE
Figure 6: Share2: 8 or 10 Wire Harness
Verify Share2 Function is Working Properly
After wiring is complete use a DC volt meter to test functionality.
Connect the volt meter negative lead to ground, then connect the
volt meter positive lead to the White wire. A measurement greater
than 4V DC should be seen when a vehicle is not connected or
not charging. A voltage less than 1V DC will be measured on the
White wire when a vehicle is charging.
NOTE:
There is a 5 second delay once one vehicle stops
charging before the White wire returns to greater than 4V
DC and an additional 10 seconds before full circuit power
will be available to the other vehicle.
*For 10 wire COSMOS harness, do not connect grey and violet wires.
