1
Based on Software Version 1.31.1. Content subject to change without notice. Check www.clintonelectronics.com for the most current manual.
DC24V
3. ALARM OUT
4. GND
1. ALARM1
3. ALARM OUT
4. GND
2. GND
NETWORK
IP
CAMERA
ON
OFF
To NVR
External
Power
Supply
To DHCP
Network
Connection
NETWORK
VIDEO RECORDER
PoE
CONNECTION DIAGRAM /
IP Camera models
4
3
5
6
7
1. Power Input
*required
This is not a PoE device!
Main device power requires
a DC24V power supply or 110VAC connection (110VAC
available on select models). Power supply not included,
sold separately.
2. Wifi Antenna
*optional
External antenna only offered on 32” and larger models.
Attach antenna if device is to be connected via Wifi.
3. IP Camera Output
*optional
Built-in IP camera output only. Connect to NVR or other
network device.
4. Power On/Off Switch
After connecting power to device, put the switch to the
ON position. Pressing the Power button on the remote
will not turn On/Off the device, it will only turn off the
LCD.
5. Alarm I/O Connections
*optional
If desired, make +/- connections from external alarm
output, such as EAS pedestal, to desired Alarm In.
Connections vary by model.
6. Network Connection
*required
This connection must either be hardwired or connected
via Wifi for the device to function properly. Cat5e or
higher network cable is recommended. Connect to
DHCP network. There is no communication between
the NETWORK and IP CAMERA ports. If the IP Camera
feed is to be viewed/recorded by an external device,
the additional IP CAMERA port must also be used.
7. VESA 75/100 Mounting hole patterns
1
2
*Actual connections may vary from the image shown.
ATTENTION:
This is NOT a PoE Device!
Power must come from DC24V or 110VAC power source!
