Climit 24 BF, Инструкция пользователя

Страница: 85 / 152

85
EN
Type No. Description Range U/M Step Default
tS 3.5 Digital / analogue Pressure switch
0 = water pressure switch
1 = water pressure transducer
2 = water pressure transducer
(only pressure displayed)
- 1 0
tS 4.0 Modulating Pump Speed
-- = No modulation
AU = Automatic 30 .. 100
% 10 AU
tS 4.1 ∆ T Modulating pump delivery/Return 10 .. 40 % 1 20
tS 4.7 System pump forcing (only in winter mode)
0 = Disabled
1 = Enabled
- 1 0
RESET
tS 4.8 INST Parameter set to default 0 .. 1 - - 0
In the event of a fault/malfunction the message
"AL"
will appear
on the display alternating with the alarm number eg. "AL 04" (Do-
mestic Hot Water Sensor Fault).
Before repairing the fault:
– disconnect the appliance from the mains power by setting the
main switch to "OFF"
OFF
Fig. 48
– as a precautionary measure, close the gas isolation valve.
Repair the fault and start-up the boiler again.
NOTE: after having repaired the fault, when the alarm number ap-
pears on the display together with the message RESET (see figu-
re), press the button o ( R ) for approximately 3 seconds to start
the appliance up again.
7.5 Display of operating data and counters
Once the boiler is operating a qualified technician can view the
operating data
"In"
and the counters
"CO"
as follows:
– from the operating screen in the mode enabled at that moment
(WINTER n or SUMMER l )
– go into
"INFO"
by pressing the buttons > and <
at the same time
for more than 3 seconds until
"In"
appears alternating with
"0.0"
(information number) and
"25"
(eg. value)
From this point, the technician has 2 options:
– scroll through the list of
"info"
and
"counters"
by pressing the
button > . This way, scrolling will be in sequence
– display the “activated alarms” (no more than 10) by pressing the
button < . Once in this section, proceed with button > or < .
When all the values have been displayed, exit the menu by pres-
sing and holding down the buttons < and o at the same time for
approximately 5 seconds until the initial screen is displayed.
TABLE OF INFORMATION DISPLAYED
Type No. Description Range U/M Step
In 0.0 SW version
In 0.1 External sensor - 9 .. 99 °C 1
In 0.2 Delivery sensor 1 tem-
perature
- 9 .. 99 °C 1
In 0.3 Delivery sensor 2 tem-
perature
- 9 .. 99 °C 1
In 0.4 Domestic hot water
sensor temperature
- 9 .. 99 °C 1
In 0.5 AUX auxiliary sensor - 9 .. 99 °C 1
In 0.6 Actual heating SET tem-
perature
Par. 13
… Par.
14
°C 1
In 0.7 Power level 0 .. 99 % 1
In 0.8 Flow meter rate 0 .. 99 l/min 0.1
In 0.9 Water pressure transdu-
cer reading (if resent)
0…99 bar 0.1