CLIMIA CMG 100, Руководство по эксплуатации

Страница: 9 / 16

9
Humidity measuring unit CMG 100
Setting the signal function
• The measuring unit also displays
three non-numeric measurement
formats: “DRY” [13] “RISK” [12] and
“WET” [13]
• When the humidity status
reaches “RISK” or “WET”, the
measuring unit will beep.
-- In the “RISK” range, the
measuring unit beeps
approximately once every 2
seconds.
-- In the “WET” range, the
measuring unit beeps about four
times per second.
• By default, a humidity reading
of <30 will display “DRY”; 30 - 60
will display “RISK”; and a reading
above 60 will display “WET”.
• Different materials have different
moisture tolerance. Please refer
to the chapter “Technical data”
in section b) Humidity limit
ranges for further information.
Programme your limit range as
follows:
-- When the “HOLD” symbol [10] is
displayed, press the SET key [4] to
enter the signal mode
-- The “RISK” symbol [12] flashes.
Press the UP key [7] or the DOWN
key [3] to adjust the lower limit
for “RISK”.
The value can be set from 0 to 50.
The factory default setting is 30.
Press the SET key [4] to confirm
your selection
-- The “WET” symbol [13] flashes.
Press the UP key [7] or DOWN key
[3] to adjust the lower limit for
9.0 Care, cleaning
and maintenance
“WET” The value can be set from
50 to 100. The factory default
setting is 60.
Press the SET key [4] to confirm
your selection
-- The LC display switches back to
the initial mode (“HOLD”)
-- The limit value is stored
permanently until it is next
changed
Backlight
• If no backlight is switched on,
press and hold the UP key (7)
for some time to switch on
the backlight. The LC display is
illuminated by white LEDs.]
• If the backlight is switched on,
press and hold the UP key (7)
for a few seconds to switch off
the backlight. The LC display is no
longer illuminated
Care and cleaning
• Disconnect the product from
the power supply before any
cleaning
• Never use aggressive cleaning
agents, cleaning alcohol or other
chemical solutions, as this may
attack the housing or even impair
its function
• Use a soft, dampened, lint-free
cloth to clean the product
• Use only clean water to moisten
the cloth
Maintenance
The housing of the humidity
measuring unit can be opened for
maintenance by a specialist.
• To open the housing, remove the
housing screws and the plastic
knurled nut on the lower shaft
in an anticlockwise direction. It
is now possible to separate the
two halves of the housing. To
reassemble the housing, carry
out the process in reverse
10.0 Scope of delivery
• Humidity measuring unit
• 1 x 9 V block battery
• Operating manual