28
6. Operation
6.1 Answering Incoming Calls
VCP-LTE will ring when there is an incoming call.
The user can press the VCP-LTE
’s Alarm Button to pick up the call.
If
“Answer Incoming Calls” is set as Enable(Auto-Answer), VCP-LTE will
auto-answer an incoming call after the first ring, and depending on the setting of
“Incoming all Check Access Code”, VCP-LTE will check the Access Code or not
before it opens a full-duplex Two-way communication. (Pease see
4.1.5. Setting
)
If the number of the incoming call matches any of the Caller ID, VCP-LTE will
instantly pick up the call (without checking Access Code).
Press a DTMF key for over 1 second to enable a designed shortcut function.
- Enter (
1
) to talk only.
- Enter (
2
) to open two-way voice communication.
- Enter (
3
) to listen in only.
- Enter (
9
) to hang up. You can also put the handset back to the base cradle to
end the call.
Press VCP-LTE
’s Alarm Button for 5 seconds to hang up or press the learnt-in RF
device (WTR, Fall Sensor or PB) button once to hang up.
The caller can press either DTMF (9) key or put the handset back to the base cradle
to hang up.
Pressing any DTMF (except DTMF 9) can reset the communication time to the
preset duration.
<NOTE>
The function of pressing sensor button to end call is now programmable via PC
Programming Tool or SMS command. Default is disabled.
6.2 Alarm Activation
Press the Alarm Button of VCP-LTE to or press the Active Button of the learnt-in RF
device (WTR, Fall Sensor or PB), or pull the cord of PCU to activate alarm.
VCP-LTE will enter guard time.
When a fall is detected from the learnt-in Fall Sensor, VCP-LTE will enter guard
time fall sensor and begin report when guard time fall sensor expires.
When VCP-LTE is activated while having a Cellular Network fault (Red LED flashes
once every 5 seconds), it will emit 3 beeps as a local warning.
Guard Time
After VCP-LTE is activated, it will begin counting down the Guard Time and begin
reporting after Guard Time has expired.