Climax KM3000, Руководство по эксплуатации

Страница: 33 / 104

P/N 16325, Rev. 10 Page 21
3.5 S
TUB
-
END MOUNTING
The mounting base of the key mill can
extend beyond the end of a shaft provided
the bar clamp is inboard not less than 1.5"
(38 mm). See Figure 3-4
Do the following:
1. Set the key mill with the mounting
base extending over the end of the
shaft. The main spindle will be
inward from the end of the shaft.
2. With the bar clamp close to the end
of the shaft, proceed setting up as
described in Section 3.4 on page 19.
3.6 L
ARGE SHAFT MOUNTING
Using the optional chain clamp assembly, shafts up to 10.5" (267 mm) in diameter
can be milled.
F
IGURE
3-5. L
ARGE SHAFT MOUNTING
Proceed as described in Section 3.4 on page 19.
Do the following:
1. Hook the chain onto the small clamp block.
2. Set the rocker onto the large clamp block.
F
IGURE
3-4. S
TUB END MOUNTING