Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 28 / 94

Page 16 BG22 Boiler Gun Operating Manual
1. Position the machine on a solid support to
change the center shafts.
2. Remove the locking rod, rod wrench and wedge
or collet locking sets.
3. Remove the two screws in the retaining plate
and the lift the retaining plate from the
machine body. Be aware of the thrust bearing
parts during disassembly
4. Remove the feed nut from the center shaft.
5. The center shaft can now be removed through
the front of the machine.
6. Install the other center shaft from the front of
the machine threads first.
7. Replace the thrust bearing parts being mindful
of the order and orientation.
8. Thread the feed nut onto the center shaft until
the center shaft is flush with the back of the
feed nut.
9. Reinstall the retaining plate and secure with the
two screws.
3.3 M
ACHINE MOUNTING
Do the following to mount the BG22 Boiler Gun on the
workpiece:
1. Insert the mounting system end of the BG22
Boiler Gun into the workpiece until there is
approximately .50” (12.7mm) between the end
of the mounting system and the face of the
workpiece. This will provide enough material
for most procedures.
2. Tighten the mounting system by turning the lock
rod clock-wise using either the rod wrench or
the speed wheel. Once snug, verify that the
mounting system position in the workpiece has
been maintained. Completely tighten the
mounting system using the locking rod wrench.
F
IGURE
3-5. C
HANGING THE CENTER SHAFT
F
IGURE
3-6. BG22 B
OILER
G
UN INSTALLED IN WORKPIECE
.50”
F
IGURE
3-7. L
OCKING ROD WRENCH WITH SPEED WHEEL