Climax H&S BOILER GUN BG22, Руководство по эксплуатации, Страница: 26 / 94

Page 14 BG22 Boiler Gun Operating Manual
3.2 M
ACHINE
S
ETUP
Do the following to setup the BG22 Boiler Gun:
3.2.1 Wedge locking system
1. Complete the risk assessment checklist in Table
1-2 on page 5.
2. Position the machine on a solid support for
installation of the wedge set.
3. Measure the ID of the pipe to be machined. Use
the chart on the inside lid of the shipping con-
tainer to determine the size of the base wedge,
extension set and locking rod.
4. Install the locking rod from the front of the
machine, sliding it through the center shaft.
5. Install the speed wheel/rod wrench on the end
of the locking rod and install the lock nut.
6. Slide the base wedge set over the end plate by
expanding the springs or band spring.
7. Seat the base wedges in the end plate and align
the base wedges with the slots in the center
shaft.
8. If installing wedge extensions, secure three of
the same size range onto the base wedges with
the screws.
3.2.1.1 Small I.D. wedge locking system
The small ID wedge locking system allows the BG22
Boiler Gun to mount on IDs of .500-.625”.
Do the following to setup the small ID wedge locking
system. 1. Position the machine on a solid support for
installation of the wedge system.
2. Follow the instructions for changing the center
shafts, if necessary, in Section 3.2.4.
F
IGURE
3-1. BG22 B
OILER
G
UN MAIN COMPONENTS
F
IGURE
3-2. I
NSTALLED WEDGE SET WITH EXTENSIONS