Climax CTC-1052-QT, Руководство пользователя

Страница: 17 / 58

13

Alarm activated by pressing a button
cannot be cancelled after the Guard Time is
elapsed.
<NOTE>

The Guard Time Delay time from
pressing the Active Button on a Fall
sensor is determined by Command #42
instead of Command #66.

The Guard Time Delay from a fall
detection (of a Fall Sensor) is set by
Command #66 .
Command 43
Periodic Test Call

CTC-1052-QT can be programmed to make
test calls periodically from (00) (no test call)
to every (1) - (7) or 30 days:
Function Selection Result
(0) OFF
(1) - (7) 1 - 7 DAYS
(8) 30 DAYS

Factory Default is set as ( 0 ), OFF .
<NOTE>

Whenever programming mode is
accessed, CTC-1052-QT will reset the
Periodic Test Call timer.

Periodic Test Call will only function with
telephone numbers assigned to
SMS
reporting method in Command 20-24.
Command 44
Mobility Timer
This function monitors user movement around
the premises and sends an inactivity report to
the Monitoring Center if the user fails to reset
the inactivity timer.

This will disable or enable the Inactivity Timer
with selectable count down periods. Options
are:
Function Selection Result
(00) DISABLE
(01) 1HR
(02) 2HR
...
....
...
...
....
..
(36) 36HR

Factory Default is set as ( 00 ), DISABLE .
<NOTE>

The Mobility Timer counting down can
be reset by:
1.
Pressing the Test/Reset Button on
CTC-1052-QT, or,
2.
Movement detected by PIR
Detector
3.
Only workable by entering 2 digits.

When Mobility Timer expires and no
reset signal is received, CTC-1052-QT
will start to emit one long beep every 5
minutes to alert the user. After 30
minutes, if reset signal is not received,
a mobility alarm reporting will be made.

The reporting method for mobility alarm
is the same as the emergency alarm.
The report will be sent based on your
reporting methods without guard time
waiting.

When ( 00 ) is selected, no code is sent
to Monitoring Center.

When CTC-1052-QT is in idle mode,
press and hold the Multi-function
Button for 15 seconds, until you hear a
long beep. Release the button and the
Mobility timer will be stopped.
Command 45
Follow-On Mode Choice

This Command is only available when
Command #38 is set as (
0 ) or ( 2 ).

It is used to select the Follow-On Choice for
CTC-1052-QT after it has made a report to
the Monitoring Center.

After reporting, CTC-1052-QT can wait for
further commands, or enter a Two-Way Full