17
During this time period, a continuous series
(1 beep every 0.5 second) of beeps will be
emitted to alert user.
If a false alarm is triggered by a fall
detection, it can be cancelled within the
Guard Time Delay by pressing the
Active
Button
of the Fall Sensor for 4 seconds.
Function Selection
Result
(00)
INSTANT REPORTING
(01) - (99)
DELAY
Factory Default is (
15
),
15 SECONDS
.
<NOTE>
This command is used if a fall is
detected.
If an emergency alarm is triggered by
pressing the Active Button on Fall
sensor, the guard time delay time is
determined by Command 42.
Command 67
Setting the Help Arrived Timer
This command is used to set the countdown
timer for CTC-1052-QT to resend the alarm
report if no help has arrived after the initial
report is made (meaning the reset button
has not been pressed before the timer
expires).
Function Selection
Result
(01)-(15)
1-15 MINUTES
Factory default is (
15
),
15 MINUTES
.
<NOTE>
The Help Arrived function (Command
33
)
must be set as
ON
for this function to
work.
Command 75
Help Not Arrived Call
If help has not arrived after sending the
alarm report for 4 times, CTC-1052-QT will
dial the telephone number programmed by
Command
75
and
open
two-way
communication when the call is answered.
Enter a telephone number followed by (#)
to program the telephone number.
<NOTE>
When you program the phone number,
entering (
) will cause a 3-second
pause is for a switchboard system,
extension, etc.
The telephone number can contain up
to 20 digits, including (
).
The Help Arrived function (Command
33) must be set as ON for this function
to work.
CTC-1052-QT only dials this telephone
number once. If this phone call fails,
CTC-1052-QT will not try again.
Command 76
Call Progress Tone
This command is used to turn on/off the
dialing tone of phone calls while making
alarm reporting.
Function Selection
Result
(0)
OFF
(Disable)
(1)
ON
<NOTE>
When this function is set to
ON
, you will
hear a dialing tone from the speaker
indicating the status of phone calls.
When this function is set to
OFF
, you
will not hear the dialing tone of phone
calls.
This function will be disabled if
Command 35
is set as
Enable
.
This function will be disabled if alarm
activation is made from a
Silent
Device
(learnt using Command #93).
Factory default is (
0
),
OFF
.
Command 77
Speech Report ACK
A two-way communication is established
when a call is made from CTC-1052-QT to
