31
32# Audible Fault Alert:
-
When turned on, 1052-QT will sound warning beeps every 30 seconds for AC Failure.
-
When turned off, 1052-QT will NOT sound warning beeps for a fault situation.
33# Help Arrived Signaling:
-
This function is available for SMS reporting and GPRS reporting methods. It is used for the
Monitoring Center personnel to confirm if the help has arrived for the user or not.
-
If Help Arrived Signaling is set to ON, once the Alarm Reporting is completed, the RED HELP
BUTTON will start to flash as the panel enters Help Arrived Mode. Press the TEST/RESET
BUTTON when the Help arrives, 1052-QT will report to monitoring center and the RED
BUTTON will stop flashing. If the TEST/RESET is not pressed within the programmed Help
Arrived Timer, 1052-QT will send one more Help Call report to summon help and inform the
Monitoring Center that no help has arrived.
-
If Help Arrived Signaling is set to OFF, once the Alarm Reporting is completed, 1052-QT will
return to idle mode.
34# Emergency Button Enable:
-
When this function is programmed as
Button On
, the RED HELP BUTTON is activated. When
pressed, it will send an Emergency alarm report to the Monitoring Station.
-
When this function is programmed as
Button Off
, the RED HELP BUTTON is deactivated.
35# Silent Mode:
-
When Silent Mode is On, all normal operation warning beeps, guard time tone, key tone and
rings will be silenced. Speech Reporting made under Silent Mode will automatically be switched
to Listen-in, but call recipient can press DTMF keys to open two-way communication or change
modes.
-
If Ringer is Enabled for Incoming Calls, CTC-1052-QT will emit ring tone for incoming calls even
in silent mode.
-
Silent mode will not mute the long beep emitted during walk test.
-
When Silent Mode is Off, all warning beeps, guard time tone, key tone and rings will function
noramlly.
37# AC Fault Report:
-
When set to ON, CTC-1052-QT will send a Fault Report after a continuous one hour of AC
Fault condition is detected.
-
When set to OFF, CTC-1052-QT will not send an AC fault report.
38# Follow-On & Call-Back Function:
-
When selected as
“Follow-On”
, after a successful reporting to the Monitoring Center, CTC-
1052-QT will automatically enter the specific Follow-On mode as specified by Command (
45
).
-
When selected as
“Call-Back”
, after a successful reporting to the Monitoring Center, CTC-
1052-QT will automatically hang up the line and start a 5-minute waiting period to auto answer
any incoming phone calls from the Monitoring Center.
-
When selected as
“Follow-On & Call-Back”
, after a successful reporting to the Monitoring
Center, CTC-1052-QT will automatically enter specific Follow-On mode as specified by
Command (
45
). Once Follow-On Mode is terminated, CTC-1052-QT will automatically start a
5-minute waiting period to auto answer any incoming phone calls from the Monitoring Center.
40# Set Access Code:
